Listing Commands; Figure 22 Display Calibration; Figure 23 ^D323) - List Enablements Example - Microcom LDS2 Programming Manual

Diagnostics and Troubleshooting Chapter 5
Figure 22 Display Calibration
5.1.3

Listing Commands

Commands used to report information regarding the printer setup.
The printer will print the Status label after the printer has performed powered up and enters
the diagnostic mode. The status label prints out the reports that are generated by the
"^D323)", "^D326)", "^D325)", and "^D324)" commands.
Figure 23 ^D323) - List Enablements Example
5-2 LDS2 Programming Manual - 880019-0202