D300)N (Print Command); D305)1 (Infinity Print Command); D311)1 (Top-Of-Form); D312)N (Form Feed) - Microcom LDS2 Programming Manual

Chapter 2
setting as well as the verbose description and help text associated with that particular
command.
2.3.1 ^D300)n
This command will print a label or a batch of labels where "n" controls how many labels of
the identical script are printed. When this command is used within a script file, it should be
placed at the end of the ^D commands. The "^D300)" command is equivalent to the ^P
(ASCII 0x10) control code.
2.3.2 ^D305)1
Issuing this command will initiate infinity printing. The printer will continue to print until the
machine turns off. This command may be sent from outside or from inside a script file.
2.3.3 ^D311)1
This command uses the Label Present Sensor to detect the edge of the media and retracts
the leading edge of the media the start position which is just behind the TOF sensor. The
"^D311)" command is equivalent to the ^O (ASCII 0x0F) control code.
2.3.4 ^D312)n
This command causes the printer to feed or scroll a form size that is based upon the
previous script's configuration where "n" controls how many copies are issued. The form
determined by the last label size that was processed. This command can be used inside
and/or outside a script file. The "^D312)" command is equivalent to the ^L (ASCII 0x0C)
control code.
2.3.5 ^D313)n1,n2
This command used to advance the media by a programmable distance (n1) at a
programmable speed (n2). The distance and speed parameters are specified in the current
selectable units ("^D564)" and "^D565)") commands. A negative distance for the n1
parameter causes the printer to retract the specified amount at the speed entered with the
n2 parameter.
2.3.6 ^D323)n
The "^D323)" command will list the printers current configurable enablements along with
each of the individual enablement specific ^D7xx command. This command should only be
issued from outside a script file and not issued in a script file. The valid parameters for "n"
are listed below. If the ^D command is issued without a parameter, the default will be used.
The "^D323)" command is equivalent to the ^Y (ASCII 0x19) immediate control code.
1 through active port (default)
2 print out
2.3.7 ^D324)n
This command used to report the printer's status such as the firmware version,
communication parameters, memory information, and basic usage statistics. The "^D324)"
command is equivalent to the ^W (ASCII 0x17) control code.
1 through active port (default)
2 print out
2-6
(Print Command)
(Infinity Print Command)
(Top-OF-Form)
(Form Feed)
(Advance Media)
(List Enablements)
(List Statistics)
LDS2 Programming Manual - 880019-0202
Printer Commands