D673)N (Set Dhcp); D674)N (Set Ethernet Port Number); D675)N (Set Printer Ip Address); D677)N (Set Gateway Ip Address) - Microcom LDS2 Programming Manual

Printer Commands
communicate properly. The "^D670)" command defaults to 9600,n,8,1 when the printer
enters the diagnostic mode by pressing the print button in while applying power.
Command Syntax: ^D670) b, p, d, s
Parameter
b
p
d Data word width
s
2.5.25 ^D673)n
This command is used to set or enable/disable the Ethernet DHCP. The printer ships from
the factory with DHCP enabled (^D673)1). If the host does not assign a DHCP within 30
seconds, the printer will automatically assign an Auto IP address. If a static address is
desired, the DHCP should be disabled; ^D673)0.
2.5.26 ^D674)n
The "^D674)" command is used to set the printer's Ethernet port number. This command is
provided in all access modes. The recommended Stream Printing Ethernet port is "9100".
The printer uses the new settings only after a power cycle and/or reset command. This is
typically set to 9100.
2.5.27 ^D675)n
This command is used to set the printer's IP address. This command is provided in all
access modes. The default address is set to "255.255.255.255" at the factory. The printer
uses the new settings only after a power cycle and/or reset command. This is typically set to
your IP address.
2.5.28 ^D677)n
The "^D677)" command is used to set the Gateway IP address. This command is provided
in all access modes. The default Gateway address is set to "255.255.255.255" at the
factory. The printer uses the new settings only after a power cycle and/or reset command.
2.5.29 ^D679)n
This command is used to set the Net Mask address. This command is provided in all
access modes. The default Net Mask address is set to "255.255.255.255" at the factory.
The printer uses the new settings only after a power cycle and/or reset command. This is
typically set to 255.255.255.0.
2.5.30 ^D680)n
The "^D680)" command is used to set the Gap threshold. The printer's default threshold is
set to "30" and typically does not require any adjustment. The command is provided in all
LDS2 Programming Manual - 880019-0202
Parameter
Description
Baud rate 1200,9600,19200,38400,57600,115200,230400
Parity
Stop bits
Table 8
(Set DHCP)
(Set Ethernet Port Number)
(Set Printer IP Address)
(Set Gateway IP Address)
(Set Net Mask Address)
(Set Gap Threshold)
Valid Arguments
n = none, o = odd, e = even
7, 8
1, 2
^D670) Parameters
Chapter 2
2-23