D635)N (Set Print Speed); D636)N (Set Detection Mode); Detection Mode - None (0); Figure 6 Detection Mode - None - Microcom LDS2 Programming Manual

Chapter 2
2.5.7 ^D635)n
The "^D635)" command sets the print speed of the printer using the current selected unit of
measure. Parameter "n" has a range of 1-6 inches per second or 2.54 - 15.24 cm/second.
This command is also a parameter in the "^D200)" script header command. See also, SPD.
2.5.8 ^D636)n
This command selects the type of method the printer uses for detecting registration marks
on the different media types. A selection of a "0" disables the detection of registration marks
and used in conjunction with media that does not contain a registration mark like continuous
media. A selection of a "1" uses the reflective detection method and is used when detecting
registration marks located on the bottom side of the media. A selection of a "2" uses the
transmissive detection method which can be used with any type of media but is not
recommended when only detecting registration marks located on the bottom side of the
media. A selection of a "3" also uses the transmissive detection method and is used in
conjunction with media containing a blowhole. Both upper and lower gap detectors are
required for stock out detection regardless of the type of registration mark detection. This
command is also a parameter in the "^D200)" script header command. See also, DET.
0 None
1 Blackline
2 Die-cut
3 Blowhole
2.5.8.1

Detection Mode - None (0)

This mode is typically used with continuous media. Even though it is not necessary to
sense a registration mark, it is still important that the Upper and Lower Sensors are
vertically aligned to sense out-of-stock or stock out conditions.
Emitter
(Not Used)
Detector
(Not used)
2-18
(Set Print Speed)
(Set Detection Mode)
(gap sensors are disabled)
(lower gap sensor is enabled)
(upper and lower gap sensors are enabled)
(upper and lower gap sensors are enabled)
Upper Sensor
Lower Sensor
Figure 6 Detection Mode - None
Printer Commands
Detector
Emitter
LDS2 Programming Manual - 880019-0202
Label
Stock