File Not Found< (D6); Inadequate Access Mode< (D7); Inadequate Flash Space< (Da); File Too Large< (F2) - Microcom LDS2 Programming Manual

Diagnostics and Troubleshooting
5.3.21 >FILE NOT FOUND< (D6)
The ">FILE NOT FOUND<" response typically indicates that the printer is being instructed to
recall and process a file that does not exist in the printer's memory while in text and verbose
response sets. If the printer is configured for byte responses, the code ASCII 0xD6 will be
issued from the printer in response to an enquiry command.
5.3.22 >INADEQUATE ACCESS MODE< (D7)
This enquiry response is typically issued when the user is attempting to issue a persistent
command that is not allowed by the current access mode level or is attempting to enter an
access mode that has a higher security level. If the printer is configured for byte responses,
the code ASCII 0xD7 will be issued from the printer in response to an enquiry command.
5.3.23 >INADEQUATE FLASH SPACE< (DA)
This enquiry response indicates that the available flash memory is less than the total size of
a file being saved to flash memory. If the printer is configured for byte responses, the code
ASCII 0xDA will be issued from the printer in response to an enquiry command.
5.3.24 >FILE TOO LARGE< (F2)
This enquiry response indicates that the graphic sent to the printer is larger than the
available memory while in text or verbose response sets. If the printer is configured for byte
responses, the code ASCII 0xF2 is issued from the printer in response to an enquiry
command.
5.3.25 >POWERED DOWN< (FF)
The ">POWERED DOWN<" response indicates that the printer's power has been
interrupted while in text and verbose modes. If the printer is configured for byte responses,
the code ASCII 0xFF will be issued from the printer in response to an enquiry command.
This message also indicates that the printer was successful writing pending updates to flash
on a power loss situation.
5-12 LDS2 Programming Manual - 880019-0202
Chapter 5