Microcom LDS2 Programming Manual page 113

to identify printhead dots that might have an issue. The size of the
printout uses the last executed script header or the nonvolatile header ^D
command settings.
^D VALUE COMMAND
971 n Edit Inches Printed Statistic: Command used to edit the Printed Inches
counter. Must have access level of SERVICE or FACTORY to edit.
973 n Edit Power on Statistic: Command used to edit the Power on Hours
counter. Must have access level of FACTORY to edit.
974 n Edit Head Up Cycles: Command used to edit the Head Up
counter. Must have access level of FACTORY to edit.
975 n Clear All Statistics: Command used to Clear and zero all
counters. Used as part of setup at the factory. Must have access level of
FACTORY to edit.
976 n Edit Unit Serial Number: Command used to edit the printer
serial number. Must have access level of FACTORY to edit.
977 n Edit Cutter Cycles: Command used to edit the cutter cycles
counter. Must have access level of SERVICE or FACTORY to edit.
978 n Set MAC Address: Command used to set the unit
MAC Address. Must have access level of FACTORY to edit.
979 n Edit CPU Serial Number: Command used to edit the CPU Serial
number. Must have access level of SERVICE or FACTORY to edit.
980 n Calibrate Sensors: Command used to calibrate sensors. Requires an
access mode of SERVICE or FACTORY mode and specific calibration
cards to perform task. The value for "n:" is listed below.
0 = Calibrate all sensors
1 = Calibrate Reflective sensor
2 = Calibrate Transmissive sensor
3 = Calibrate LPD sensor
6-14 LDS2 Programming Manual - 880019-0202