Accessing Via Mobile Client - HIKVISION DS-2TD6267-75C4L/W User Manual

DS-2TD6267-75C4L/W Thermal & Optical Bi-Spectrum PTZ Network Camera User Manual
Steps
1. Go to Configuration → Network → Basic Settings → PPPoE.
2. Check Enable PPPoE.
3. Set the PPPoE parameters.
•
Dynamic IP: After successful dial-up, the dynamic IP address of the WAN is displayed.
•
User Name: User name for dial-up network access.
• Password: Password for dial-up network access.
•
Confirm: Input your dial-up password again.
4. Click Save.
5. Access the device.
•
By Browsers: Enter the WAN dynamic IP address in the browser address bar to access the device.
•
By Client Software: Add the WAN dynamic IP address to the client software. Refer to the client
manual for details.
NOTE: The obtained IP address is dynamically assigned via PPPoE, so the IP address always
changes after rebooting the camera. To solve the inconvenience of a dynamic IP, get a
domain name from a DDNS provider (e.g., DynDns.com). Refer to
Name
for detailed information.

12.8. Accessing via Mobile Client

Hik-Connect is an application for mobile devices. Using the app, you can view live images, receive alarm
notifications, etc.
NOTE:
Hik-Connect service should be supported by the camera.
Enable Hik-Connect Service on Camera
Hik-Connect service should be enabled on your camera before using the service. You can enable the
service through SADP software or a Web browser.
Enable Hik-Connect Service via Web Browser
Follow the following steps to enable Hik-Connect Service via a Web Browser.
Before You Start
You need to activate the camera before enabling the service.
Steps
1. Access the camera via a Web browser.
UM DS-2TD6267-75C4L/W 042221NA
Access to Device via Domain
76