Multicast; Snmp - HIKVISION DS-2TD6267-75C4L/W User Manual

DS-2TD6267-75C4L/W Thermal & Optical Bi-Spectrum PTZ Network Camera User Manual
Set Auto Port Mapping
Steps
1. Check Enable UPnP
2. Set the port mapping mode to Auto.
3. Click Save.
NOTE:
UPnP function on the router should be enabled at the same time.
™
Set Manual Port Mapping
Steps
1. Check Enable UPnP
2. Set the port mapping mode to Manual, and set the external port to be the same as the internal port.
3. Click Save.
What To Do Next
Go to the router port mapping settings interface and set the port number and IP address to be the same as
those on the device. For more information, refer to the router user manual.

12.4. Multicast

Multicast is group communication where data transmission is addressed to a group of destination devices
simultaneously. After setting multicast, you can send the source data efficiently to multiple receivers.
Go to Configuration → Network → Basic Settings → Multicast for the multicast settings.
• IP Address: The address of the multicast host.
• Stream Type: The stream type as the multicast source.
• Video Port: The video port of the selected stream.
• Audio Port: The audio port of the selected stream.

12.5. SNMP

You can set the SNMP network management protocol to get the alarm event and exception messages in
network transmission.
Before You Start
Before setting the SNMP, download the SNMP software and manage to receive the device information via
the SNMP port.
UM DS-2TD6267-75C4L/W 042221NA
, and choose a friendly name for the camera, or use the default name.
™
™ , and choose a friendly name for the device, or use the default name.
74