HIKVISION DS-2TD6267-75C4L/W User Manual page 77

DS-2TD6267-75C4L/W Thermal & Optical Bi-Spectrum PTZ Network Camera User Manual
2. Enter the platform access configuration interface, Configuration → Network → Advanced Settings →
Platform Access.
3. Set Hik-Connect as the Platform Access Mode.
4. Check Enable.
5. Click and read "Terms of Service" and "Privacy Policy" in the pop-up window.
6. Create a verification code or change the old verification code for the camera.
NOTE: The verification code is required when you add the camera to Hik-Connect service.
7. Save the settings.
Enable Hik-Connect Service via SADP Software
This section introduces how to enable Hik-Connect service via SADP software of an activated camera.
Steps
1. Run SADP software.
2. Select a camera, and enter the Modify Network Parameters page.
3. Check Enable Hik-Connect.
4. Create a verification code or change the old verification code.
NOTE:
The verification code is required when you add the camera to Hik-Connect service.
5. Click and read "Terms of Service" and "Privacy Policy."
6. Confirm the settings.
Set Up Hik-Connect
Steps
1. Get and install the Hik-Connect application in the following ways.
•
Visit https://appstore.hikvision.com to download the application according to your mobile phone
system.
Visit the official site of our company. Then go to Support → Tools → Hikvision App Store.
•
•
Scan the QR code below to download the application.
UM DS-2TD6267-75C4L/W 042221NA 77