Set Power Off Memory; Set Ptz Priority - HIKVISION DS-2TD6267-75C4L/W User Manual

DS-2TD6267-75C4L/W Thermal & Optical Bi-Spectrum PTZ Network Camera User Manual
Set Auto Compass
For a device that has a built-in e-compass, the compass can automatically tell the north direction for the
device.
Before You Start
Electromagnetic interference may affact the accuracy of the e-compass. Use a manual compass if
electromagnetic interference occurs in the device installation environment.
Steps
1. Select the PT Mode as Auto.
2. Click Calibrate to the north of the device with that of the e-compass.

8.12. Set Power Off Memory

This function can resume the previous PTZ status of device after restarting from a power-off.
Steps
1. Go to Configuration → PTZ → Basic Settings.
2. Select Resume Time Point. When the device stays at one position for the set resume time point or more,
the position is saved as a memory point. The device returns to the last memory point when it restarts.
3. Click Save.

8.13. Set PTZ Priority

The function can set the PTZ priority of different signals.
Steps
1. Go to Configuration → PTZ → Prioritize PTZ.
2. Set the priority signal and delayed time.
•
Network: The network signal controls the device with priority.
•
RS-485: The RS-485 signal controls the device with priority.
•
Delay: The time interval of PTZ operation controlled by different signals. When the operation with
high priority is finished, the low priority signal controls the device after the setting interval.
3. Click Save.
UM DS-2TD6267-75C4L/W 042221NA 48