Access To Device Via Domain Name; Access To Device Via Pppoe Dial-Up Connection - HIKVISION DS-2TD6267-75C4L/W User Manual

Thermal & optical bi-spectrum ptz network camera
Hide thumbs Also See for DS-2TD6267-75C4L/W:
Table of Contents

Advertisement

DS-2TD6267-75C4L/W Thermal & Optical Bi-Spectrum PTZ Network Camera User Manual
Steps
1. Go to the settings page: Configuration → Network → Advanced Settings → SNMP.
2. Check Enable SNMPv1, Enable SNMP v2c, or Enable SNMPv3.
NOTE:
The SNMP version you select should be the same as that of the SNMP software.
You also need to use the version according to the security level required. SNMP v1 is not
secure, and SNMP v2 requires a password for access. SNMP v3 provides encryption, and if
you use the third version, HTTPS protocol must be enabled.
3. Configure the SNMP settings.
4. Click Save.

12.6. Access to Device via Domain Name

You can use Dynamic DNS (DDNS) for network access. The dynamic IP address of the device can be mapped
to a domain name resolution server to realize network access via a domain name.
Before You Start
Registration on the DDNS server is required before configuring the DDNS settings of the device.
Steps
1. Refer to TCP/IP to set DNS parameters.
2. Go to the DDNS settings page: Configuration → Network → Basic Settings → DDNS.
3. Check Enable DDNS and select DDNS type.
DynDNS: Dynamic DNS server is used for domain name resolution.
NO-IP: NO-IP server is used for domain name resolution.
4. Input the domain name information, and click Save.
5. Check the device ports and complete port mapping. Refer to Port to check the device port, and refer to
Port Mapping
for port mapping settings.
6. Access the device.
By Browsers: Enter the domain name in the browser address bar to access the device.
By Client Software: Add domain name to the client software. Refer to the client manual for specific
adding methods.

12.7. Access to Device via PPPoE Dial-Up Connection

This device supports the PPPoE auto dial-up function. The device gets a public IP address by ADSL dial-up
after the device is connected to a modem. You need to configure the PPPoE parameters of the device.
UM DS-2TD6267-75C4L/W 042221NA
75

Advertisement

Table of Contents
loading

Table of Contents