Set Initial Position; Set Scheduled Tasks - HIKVISION DS-2TD6267-75C4L/W User Manual

DS-2TD6267-75C4L/W Thermal & Optical Bi-Spectrum PTZ Network Camera User Manual
5. Click Save.
6. Check Enable Limit.
If you need to cancel all the set patrol paths, go to Configuration → PTZ → Clear Config, select
NOTE:
Clear All PTZ Limited, and click Save.
Result
The device can move only within the set region after saving the settings.
8.7.

Set Initial Position

Initial position refers to the relative initial position of the device azimuth. You can set the initial position if
you need to select one point in the scene as the base point.
Steps
1. Go to Configuration → PTZ → Initial Position.
2. Move the device to the needed position by manually controlling the PTZ control buttons.
3. Click Set to save the information of initial position.
•
Call: The device moves to the set initial position.
•
Clear: Clear the set initial position.
8.8.

Set Scheduled Tasks

You can set the device to perform a certain task during a certain period.
Steps
1. Go to Configuration → PTZ → Scheduled Tasks.
2. Check Enable Scheduled Task.
3. Select the task type and set the period. For setting the period, refer to Set Arming Schedule.
4. Repeat step 3 to set more than one scheduled task.
5. Set Park Time. During the set task period, if you operate the device manually, the scheduled task will
suspend. When manual operation ends, the scheduled task will resume after the set park time.
6. Click Save.
To clear all scheduled tasks, go to Configuration → PTZ → Clear Config , check Clear All
NOTE:
Scheduled Tasks, and click Save.
UM DS-2TD6267-75C4L/W 042221NA 45