HIKVISION DS-2TD6267-75C4L/W User Manual page 47

DS-2TD6267-75C4L/W Thermal & Optical Bi-Spectrum PTZ Network Camera User Manual
Steps
1. Go to the setting page: Configuration → PTZ → Position Settings.
2. Select a PT Mode.
•
Manual : Use a direction indicating device to determine North at the device location, and set North
for the device. For details, see
•
Auto: For a device that has a built-in e-compass, the compass can automatically tell the north
direction for the device. For details, see
3. Check Installation Angle Calibration to perform angle calibration one time when the device installation
is finished.
NOTE:
This is used for situations where the device is not installed horizontally, to increase the fire
source detection accuracy.
4. Set Vandal-proof alarm.
After enabling the function, the device triggers alarms once its position changes because of shock or
vandalism.
•
Sensitivity: The higher the value, the easier the alarm will be triggered.
•
Upload Vandal-proof Alarm: The device uploads the alarm information when the alarm is triggered.
5. Get the device location information in advance, and input the longitude and latitude of the device
manually.
6. Click Save.
What To Do Next
If you lose direction when operating the device, click Point to North to call the north position that is saved
in the device.
Set Manual Compass
Use a direction indicating device to determine north at the device location, and set north for the device.
Before You Start
Use a direction indicating device to determine north at the device location.
Steps
1. Select the PT Mode as Manual.
2. Adjust the tilt position of the device to 0 by controlling the up arrow and down arrow on the PTZ panel.
3. Adjust the pan position to show the live view of the north direction by controling the left arrow and
right arrow on the PTZ panel.
4. Click Set as North.
UM DS-2TD6267-75C4L/W 042221NA
Set Manual Compass
.
Set Auto Compass
.
47