Set Initial Position; Set Scheduled Tasks - HIKVISION DS-2TD4668-35A4/W User Manual

Thermal & Optical Bi-spectrum PTZ Network Camera User Manual
Steps
1. Go to Configuration → PTZ → Linear Scan .
2. Select the camera channel.
3. Zoom in and zoom out the camera to the appropriate zoom ratio, and click Save Ratio.
Note
Click Enable Saved Ratio to set the camera to the saved zoom ratio.
4. Check Enter Area Settings.
5. Set the left/right/up/down limits with the PTZ control panel, and click
6. Optional: Click Clear to delete the saved scan area.
7. Click Save.
8. Click Call Linear Scan to start linear scan, and click Stop Linear Scan to stop linear scan.
Note
When setting the linear scan area, make sure the target area is both included in the optical
channel and the thermal channel.

8.5 Set Initial Position

Initial position refers to the relative initial position of the device azimuth. You can set the initial
position if you need to select one point in the scene as the base point.
Steps
1. Go to Configuration → PTZ → Initial Position .
2. Move the device to the needed position by manually controlling the PTZ control buttons.
3. Click Set to save the information of initial position.
Call The device moves to the set initial position.
Clear Clear the set initial position.

8.6 Set Scheduled Tasks

You can set the device to perform a certain task during a certain period.
Steps
1. Go to Configuration → PTZ → Scheduled Tasks .
2. Check Enable Scheduled Task.
3. Select the a task type from the drop-down list and draw a time bar on the schedule table.
4. Click the set time bar and set the action ID and smart event or VCA type.
41
to confirm settings.