Set Initial Position; Set Scheduled Tasks; Operate Wiper - HIKVISION DS-2SF8C442MXG-EL/26 User Manual

4.6 Set Initial Position

Initial position refers to the relative initial position of the device azimuth. You can set the initial
position if you need to select one point in the scene as the base point.
Steps
1. Go to Configuration → PTZ → Initial Position .
2. Move the device to the needed position by manually controlling the PTZ control buttons.
3. Click Set to save the information of initial position.
Call The device moves to the set initial position.
Clear Clear the set initial position.

4.7 Set Scheduled Tasks

You can set the device to perform a certain task during a certain period.
Steps
1. Go to Configuration → PTZ → Scheduled Tasks .
2. Check Enable Scheduled Task.
3. Select the task type and set the period. For setting the period, refer to Set Arming Schedule .
4. Repeat step 3 to set more than one scheduled tasks.
5. Set Park Time. During the set task period, if you operate the device manually, the scheduled task
will be suspended. When the manual operation is over, the device will continue to perform the
scheduled task after the set park time.
6. Click Save.
Note
If you want to clear all scheduled tasks, go to Configuration → PTZ → Clear Config , check Clear
All Scheduled Tasks, and click Save.

4.8 Operate Wiper

For the device that has a wiper, you can control the wiper via web browser.
Note
Wiper operation and settings vary on device models.
Steps
1. Go to Configuration → PTZ → Wiper .
2. Select a wiper mode.
TandemVu PTZ Camera User Manual
49