Daily Cleaning And Maintenance - Leica HistoCore SPECTRA CV Instructions For Use Manual

7
Cleaning and Maintenance

7.4.1 Daily cleaning and maintenance

A Coverglass cartridge:
• Check the coverglass cartridge for broken glass
replacing the coverglass cartridge)
• Check that the coverglass is seated correctly in the coverglass cartridge
6.3.3 Checking and replacing the coverglass
B Waste tray:
• Check the waste tray for broken glass
empty it if necessary.
C Pick&Place module:
• Check the skids, suction cups and coverglass sensor pin for residual mountant and
broken glass
(→ P. 114 – 7.2.10 Cleaning the Pick&Place
• Replace deformed and/or damaged suction cups
cups).
D Alignment pins:
• Check for residual mountant and clean if necessary (→ Fig. 3-12).
E Coverslip lines
• Check for surface-dried residual mountant and clean if necessary.
F Reagent vessels in the load drawer:
• Replace the reagent in the reagent vessel (→ P. 32 – 4.6 Refilling consumables).
G Unload drawer:
• Check if there are still racks in the unload drawer and remove
cleaning).
H Surfaces of the instrument:
• Check surfaces of the instrument for residual reagent in the area of the load drawer
and clean if necessary. For this purpose, commercial household cleaner can be used
(→ P. 105 – 7.2.1 Exterior surfaces, varnished surfaces, instrument
I Prime bottle:
• Check the fill level of the prime bottle and dispose of the contents in accordance with the
laboratory specification if necessary.
J Shifter and shifter tongue:
• Check the shifter and shifter tongue
mounting medium. Soak a lint-free cloth with xylene and remove any mounting medium
residue that may be present.
128
and clean if necessary.
(→ P. 86 – 6.3.5 Inspect Pick&Place module)
L1 and L2:
(→ Fig. 3-14)
(→ P. 82 – 6.3.3 Checking and
cartridge).
(→ P. 86 – 6.3.4 Emptying the waste tray)
and clean if necessary
module).
(→ P. 114 – 7.2.11 Exchange suction
for contamination and dried out
(→ P. 82 –
and
(→ P. 107 – 7.2.4 Interior
hood).
Version 2.1, Revision K