Emptying The Waste Tray; Inspect Pick&Place Module - Leica HistoCore SPECTRA CV Instructions For Use Manual

6
Daily Instrument Setup

6.3.4 Emptying the waste tray

Note
The HistoCore SPECTRA CV automatically detects defective/broken coverglass and places it in the
waste tray.
Warning
Wear cut-resistant safety gloves
waste tray!
1. Open the hood.
2. Check the waste tray for broken coverglasses.
3. If broken coverglass exist, remove the waste tray
4. Then insert the waste tray back in the position provided for it (→ Fig. 65-2).
5. Close the hood again.
6.3.5 Inspect Pick&Place module
1. Open the hood.
2. Check skids (→ Fig. 66-1), suction cups front and rear
pin (→ Fig. 66-3)
module).
3. Close the hood again.
86
(→ P. 18 – 3.1 Standard delivery – packing list)
Fig. 65
for dirt and clean if necessary
(→ Fig. 65-1) and clean it.
1
(→ Fig. 66-2)
(→ P. 114 – 7.2.10 Cleaning the Pick&Place
for emptying the
2
and coverglass sensor
Version 2.1, Revision K