Goalignhere; Jump Z(0) - Epson RC700 Manual

2.5.7 GoAlignHere

Since GoAlignHere have no execution parameter, the command advanced setting screen
cannot be displayed. When the command is selected, the motion command execution
confirmation screen will be displayed.
01 GoAlignHere
Go Align (Here)
Hold Enable switch.
Press the OK Key.
Key operation
OK
Cancel
Motor
Speed
Reset
Guide

2.5.8 Jump Z(0)

This section indicates settings in the command advanced setting screen.
01 Jump:Z(0)
Robot1.PTS
Point:000
Key operation
OK
Cancel
Motor
Speed
Reset
Guide
F1
RC700 / RC90 option TP2 Rev.11
L ■
Description
Fixes the parameter setting and displays the execution
confirmation screen.
Returns to the motion command selection screen.
Turns ON / OFF the motor.
Switches the speed (Low / High).
Sets the initial setup status.
Displays the key operation guide.
L ■
Description
Fixes the parameter setting and displays the execution confirmation
screen.
Returns to the motion command selection screen.
Turns ON / OFF the motor.
Switches the speed (Low / High).
Sets the initial setup status.
Displays the key operation guide.
Switches to the point number input mode.
Operation
2. TEACH Mode
81