I/O Command - Epson RC700 Manual

Operation
2. TEACH Mode

2.4 I/O Command

This section indicates settings in the [I/O Command] screen.
Execute either of the following procedures to display the screen.
Press the <F2> key in the [Jog & Teach] screen.
Press the <F6> key in the [Impedance Tester] screen.
Press the <F2> key in the [Direct Teach + Touch Jog] screen.
Input
Status
On
Off
Key Operation
▲ / ▼
Page Up / Down
OK
Cancel
Guide
Press F1 while
holding Enable
Switch
Press F2 while
holding Enable
Switch
F3
F5
74
0 Off Start
1 Off SpelProg1
2 Off SpelProg2
Description
Input bit or output bit is ON status.
Input bit or output bit is OFF status.
Description
In the Outputs status display, moves the cursor and selects the
output bit.
Changes to the previous or next page.
Returns to the previous screen.
Returns to the previous screen.
Displays the key operation guide.
Turns ON the selected output bit.
Turns OFF the selected output bit.
Switches between the Inputs / Outputs status display.
Returns to the previous screen.
RC700 / RC90 option TP2 Rev.11