Installing Tall Crop Feed Plates Under Driveline Deflector - MacDon R85 Operator's Manual

Installing Tall Crop Feed Plates under Driveline Deflector

DANGER
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and
remove the key from the ignition before leaving the operator's seat for any reason.
1. Locate the feed plates. Refer to
Tall Crop Feed Plates from Storage, page
2. Lower the header fully.
3. Stop the engine and remove the key.
4. Open the cutterbar door(s). Refer to
Doors, page 33.
6. Install feed plate (A) on the disc.
IMPORTANT:
Depending on disc (B) rotation, feed plate (A) should be
located so that when holes are aligned, the leading edge
of the feed plate is farther from accelerator (B) than the
trailing edge.
7. Install the deflector. Refer to
Deflector, page 152.
214366
OPERATING THE HEADER
4.11.1 Removing the
103.
3.5 Cutterbar
Installing the Driveline
105
Figure 4.32: Left End Shown
B
A
Figure 4.33: Left End Top View Shown
A
Revision A