4. Remove cutter disc (A) from failed spindle. Refer to
5.3.3 Removing a Cutterbar Disc, page
5. Using a 34 mm socket wrench, remove nut (A) and
washer (B) from spindle.
6. Install four M12 mm x 60 mm long bolts (A) into holes in
disc (B).
7. Use bolts (A) as jacking screws to remove flange (B)
from gear. Remove bolts from flange.
214366
MAINTENANCE AND SERVICING
138.
Figure 5.38: Cutter Disc
Figure 5.39: Cutterbar Spindle Assembly (Short
Spindle Shown)
Figure 5.40: Cutterbar Spindle Flange and
Securing Bolts
154
A
B
B
A
A
A
Revision A