Routing Hydraulic Hoses And Electrical Components To M1240 Windrowers - MacDon R85 Operator's Manual

Routing Hydraulic Hoses and Electrical Components to M1240 Windrowers

To route the R85 Header hydraulic hoses and electrical harness to the M1240 Windrower, follow these steps.
1. Move windrower left (cab-forward) platform (A) to the
OPEN position. For instructions, refer to the windrower
operator's manual.
2. Route hose bundle (A) from the header, under the
windrower frame, then insert pin (B) into hole (C) in the
windrower frame.
NOTE:
Route hoses as straight as possible and avoid rub/wear
points that could damage the hydraulic hoses.
3. Place hoses on support (D) and on the forming shield
hose support (not shown).
4. If your M1240 Windrower has factory-installed quick connect couplers, refer to
Using Quick Couplers: M1240 Windrowers, page 64
If your M1240 Windrower has factory-installed hard plumb connections, refer to
Using Hard Plumbing: M1240 Windrowers, page 65
214366
OPERATION
A
Figure 3.71: Windrower with Left Platform in
Open Position
Figure 3.72: Hydraulic Hoses
for connection instructions.
for connection instructions.
63
C
B
A
D
Connecting Header Hydraulics
Connecting Header Hydraulics
Revision A