Replacing Door Latches: Export Header; Replacing Door Latch Brackets: Export Header - MacDon R85 Operator's Manual

Replacing Door Latches: Export Header

To replace cutterbar door latches, follow these steps:
DANGER
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and
remove the key from the ignition before leaving the operator's seat for any reason.
1. Turn off the windrower's engine and remove the key from ignition.
2. Unlatch and lift the curtain.
3. Remove bolts (A) and remove latch assembly
from frame.
4. Locate new latch assembly on frame and reinstall
bolts (A).
5. Adjust to position shown and tighten bolts (A).

Replacing Door Latch Brackets: Export Header

To replace the cutterbar door latch brackets, follow these steps:
DANGER
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and
remove the key from the ignition before leaving the operator's seat for any reason.
1. Turn off the windrower's engine and remove key from
ignition.
2. Open cutterbar door.
3. Remove bolts (A), washers, and nuts, and remove latch
bracket (B) from door.
4. Locate new latch bracket (B) on door and reinstall
bolts (A), washers, and nuts. Use three washers on aft
bolt as spacers between bracket (B) and door.
5. Close door and check alignment with latch. Adjust as
necessary and tighten bolts (A).
214366
MAINTENANCE AND SERVICING
Figure 5.45: Cutterbar Door Latch
Figure 5.46: Latch Bracket
157
A
B
A
Revision A