MacDon R85 Operator's Manual page 60

6. Lift the aft end of the forming shield and attach
straps (B) to pins (A) on the windrower frame.
7. Install washer and hairpin to secure strap. Use the
middle hole and adjust height to suit the crop.
8. Set the forming shield side deflectors to the desired
width by repositioning adjuster bars (A). Use the same
hole location on both sides.
9. Adjust rear fluffer deflector (C) to the middle position.
Loosen handles (B) if required.
10. Attach the R85 header to the windrower. Refer to the
windrower operator's manual for instructions, and then
return to this manual to complete the attachment.
11. Connect the hydraulics and electrical harness.
•
For M1240, refer to
Electrical Components: M1240 Windrowers, page
62.
•
For M205, refer to
Electrical Components: M205 Windrowers, page
•
For M200, refer to
Electrical Components: M200 Windrowers, page
214366
3.7.6 Attaching Hydraulic and
3.7.3 Attaching Hydraulic and
3.7.4 Attaching Hydraulic and
OPERATION
Figure 3.26: Forming Shield Strap
B
C
Figure 3.27: Forming Shield Adjuster Bar
45.
51.
43
A
B
A
Revision A