Removing Tall Crop Feed Plates; Removing Tall Crop Feed Plates From Under Driven Deflector - MacDon R85 Operator's Manual

4.11.2 Removing Tall Crop Feed Plates

Follow these steps to remove the tall crop feed plates:
DANGER
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and
remove the key from the ignition before leaving the operator's seat for any reason.
1. Lower the header fully.
2. Stop the engine and remove the key.
3. Open cutterbar doors. Refer to
page 33.
CAUTION
Exercise caution when working around the blades.
Blades are sharp and can cause serious injury. Wear
gloves when handling blades.
4. Place a block of wood between discs to prevent
deflector from turning.

Removing Tall Crop Feed Plates from under Driven Deflector

1. Remove the deflector. Refer to
2. Remove feed plate (A).
3. Return the tall crop feed plates to the storage location. Refer to
Storage, page 107.
4. Install the deflector. Refer to
5. Close the cutterbar doors. Refer to
214366
OPERATING THE HEADER
3.5 Cutterbar Doors,
Removing the Driven Deflector, page
Installing the Driven Deflector, page
3.5 Cutterbar Doors, page
106
Figure 4.34: Cutterbar Doors
150.
Figure 4.35: Right End Shown
4.11.3 Returning Tall Crop Feed Plates to
151.
33.
A
Revision A