Installing Tall Crop Feed Plates Under Driven Deflector - MacDon R85 Operator's Manual

Installing Tall Crop Feed Plates under Driven Deflector

DANGER
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and
remove the key from the ignition before leaving the operator's seat for any reason.
1. Lower header fully.
2. Stop the engine and remove the key.
3. Open the cutterbar doors. Refer to
page 33.
4. Remove driven deflector. Refer to
Deflector, page 150.
5. Remove the tall crop feed plates from storage. Refer to
4.11.1 Removing the Tall Crop Feed Plates from
Storage, page 103.
6. Position feed plate (A) on the disc, ensuring that hole in
feed plate registers on disc. Position plate
approximately as shown and align holes.
IMPORTANT:
Depending on disc (B) rotation, feed plate (A) should be
positioned so that when holes are aligned, the leading
edge of the feed plate is farther from accelerator (B) than
the trailing edge.
8. Install the deflector. Refer to
Deflector, page 151.
9. Close the cutterbar doors. Refer to
page 33.
214366
OPERATING THE HEADER
3.5 Cutterbar Doors,
Removing the Driven
Installing the Driven
3.5 Cutterbar Doors,
104
Figure 4.30: Right End Shown
Figure 4.31: Right End Top View
A
B
A
Revision A