Removing Tall Crop Feed Plates From Under Driveline Deflector; Returning Tall Crop Feed Plates To Storage - MacDon R85 Operator's Manual

Removing Tall Crop Feed Plates from under Driveline Deflector

1. Open cutterbar doors. Refer to
2. Remove the deflector. Refer to
3. Remove feed plate (A).
4. Return feed plates to storage. Refer to
Tall Crop Feed Plates to Storage, page
5. Install the deflector. Refer to
Deflector, page 152.
6. Close the cutterbar doors. Refer to
page 33.

4.11.3 Returning Tall Crop Feed Plates to Storage

DANGER
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and
remove the key from the ignition before leaving the operator's seat for any reason.
1. Lower the header fully.
2. Stop the engine and remove the key.
3. Open the right end driveshield. Refer to
4. Remove four nuts (A) and secure nut shields (B) and
feed plates (C) to side of compartment. Reinstall
nuts (A).
NOTE:
Nut shields will not be in storage location if they are
installed on the cutterbar.
5. Install right shield. Refer to
Endshield, page 32.
214366
OPERATING THE HEADER
3.5 Cutterbar Doors, page
Removing the Driveline Deflector, page
4.11.3 Returning
107.
Installing the Driveline
3.5 Cutterbar Doors,
3.4.5 Removing Right Endshield, page
3.4.6 Installing Right
33.
151.
A
Figure 4.36: Tall Crop Feed Plate
Figure 4.37: Nut Deflector and Feed Plate
Storage
107
32.
A
B
C
Revision A