Removing And Restoring Float - M1240 Windrowers - MacDon R85 Operator's Manual

3. Press rotary scroll knob (A) on HPT to display the
QuickMenu system.
4. Rotate scroll knob (A) to highlight header float icon (B)
and press scroll knob to select.
5. Turn scroll knob (A) to highlight left (B) or right (C) float
and press knob (A) to activate selection.
6. Rotate scroll knob (A) to adjust float setting and press
knob when finished. Float is now set.
IMPORTANT:
Float adjustments of 1.0 (out of 10) change the header
weight at the cutterbar by approximately
91 kg (200 lb.). Adjust float in increments 0.05 to
optimize field performance.
7. Use soft key 3 (D) to remove/resume float and deck
position to previous setting for the attached header.
4.1.5 Removing and Restoring Float – M1240 Windrowers
Follow these steps to remove and restore the header float settings:
1. Press rotary scroll knob (A) on Harvest Performance
Tracker (HPT) to display the QuickMenu system or
press F1 on the console.
2. Rotate scroll knob (A) to highlight header float
adjust (B) and press scroll knob to select.
214366
OPERATING THE HEADER
Figure 4.4: HPT Run Screen
Figure 4.5: HPT Left/Right Float Settings
Figure 4.6: Run Screen – HPT Display
84
B
B
C
B
A
A
D
A
Revision A