Installing The Hydraulic Motor - MacDon R85 Operator's Manual

7. Cover gearbox opening (A) with a rag or plastic.

Installing the Hydraulic Motor

Follow these steps to install the hydraulic motor:
1. Remove covering from gearbox opening (A).
2. Attach a sling to the motor with the opposite end to a
lifting device.
3. Lower motor (B) on gearbox opening.
4. Install four bolts (D) and torque to 140 Nm (103 lbf·ft).
5. Remove caps from motor ports and hoses.
6. Connect case drain hose (A) to motor.
7. Connect hoses (C) to motor (B) with split flanges (E)
and torque to 64–77 Nm (47–57 lbf·ft).
NOTE:
Hydraulic connections vary depending on the
windrower. Refer to the specific instruction supplied
with your hydraulic drive kit.
214366
MAINTENANCE AND SERVICING
Figure 5.74: Hydraulic Motor Removed
Figure 5.75: Hydraulic Motor Removed
Figure 5.76: Hydraulic Motor: 16-foot
171
A
A
C
A
D
B
C
Revision A