6. Position stripper bar (A) as close as possible to auger
flighting without contacting it.
7. Repeat Steps
5, page 114
opposite side.
8. Manually rotate auger to check that auger does NOT
contact stripper bars. Readjust as required.
9. Tighten nuts (A).
NOTE:
Right side and left side stripper bars are
interchangeable. Each stripper bar can be flipped when
one bar wears out or becomes damaged.
214366
OPERATING THE HEADER
and
6, page 115
for
Figure 4.50: Right End
Figure 4.51: Stripper Bar
Figure 4.52: Left End
115
A
A
A
Revision A