Figure 45 Rs4000 With Antenna Attached - Meru Networks AP320 Installation Manual

7. Attach a keps nut to each caddy fastener stud and hand tighten. Do not
8. On the RS4000, attach the two antenna cables to the SMA antenna connectors
(Meru logo is upside down)
Figure 45: RS4000 with Antenna Attached
9. Attach at least one Ethernet cable to the Ethernet port labeled
10. Align the RS4000 to the bracket and tighten the four knurled thumbscrews until
11. Attach the antenna cables to the antenna, as described in "Placing and
12. Connect the two Ethernet cables to the PoE device.
13. Apply power to the PoE component and network switch to power up the RS4000.
14. Verify correct operating using the LEDs, as shown in
© 2008 Meru Networks, Inc.
overtighten.
labeled and
ANT1 ANT2
the cable ends clockwise until tight.
ANT1
optionally to on the top panel of the RS4000. If just ETH1 is connected, only
ETH2
two of the four radios will be active.
secure. If necessary, apply extra tightening with pliers.
Positioning the Antenna."
on the top panel of the RS4000 (see
ANT1 ANT2
ANT2
K
Installing the RS4000
Figure 43) by turning
ETH1
ETH2
and
ETH1
"Checking LED Activity."
Installing the RS4000 83