Where To Go From Here; Checking Led Activity - Meru Networks AP320 Installation Manual

this point-to-multipoint configuration all OAP180 nodes must be aligned with the root
OAP180 antenna.

Where to Go From Here

Now that the OAP180 is installed, go to the Meru System Director Getting Started Guide
for instructions on initializing the controller and connecting the controller and APs to the
Ethernet switch to form the WLAN. Return to this chapter to check the status of the LEDs
once the WLAN is operational.
As well, check the AP chapter in the Meru System Director Configuration Guide for
instructions on configuring radio band, dual radio, and external antenna operation.

Checking LED Activity

Check the OAP180 LEDs for activity. Four of the eight LEDs on the bottom of the OAP180
indicate activity; four LEDs are not used at this time. Check the four active LEDs to deter-
mine if the AP is working.
These 4 LEDs
are not used
© 2008 Meru Networks, Inc.
Console PoE
Power On
LED
Ethernet link
LED
Transmission LEDs
(radio packets transmitting)
Where to Go From Here
Installing the OAP180 55