Figure 16 Ap200 Connector Panel; Figure 17 Ap200 Bracket - Meru Networks AP320 Installation Manual

Figure 16: AP200 Connector Panel
Vertical Mounting
To vertically mount an AP:
1. Using the bracket holes as a template, mark the location on the wall for the two
Wall cable access
Access point mount
Suspended ceiling
cable access
Figure 17: AP200 Bracket
© 2008 Meru Networks, Inc.
(Reserved)
Console
Antenna 1
port
CONSOLE
ANT 1
AP bracket mounting screws. They are placed 4 ½ inches apart, center-to-center,
one above the other. If you are not using plastic wall anchors, you must center
the mounting screws on a wall stud. If you do not center the mounting screws on
a wall stud, you must use plastic wall anchors.
Reset
100/1000
(Push to restore
Ethernet
default settings)
ETHERNET
Ceiling mount hole
Ceiling mount hole
Installing the Access Points
(Currently
unsupported)
Power Antenna 2
inlet
3.3 VDC
ANT 2
Access point mount
Locking detent
Access point mount
Installing the AP200 33