Figure 12 Attaching The Mounting Bracket To The Box Hanger - Meru Networks AP320 Installation Manual

Access point and radio switch
Table of Contents

Advertisement

3. Locate the bracket mounting clip holes on the mounting bracket (see
the bracket perpendicular to the box hanger; the other mounts the bracket parallel to the box
hanger.
4. Attach the U-joint of the clip to the T-bar and snap in place (see
Figure 12: Attaching the Mounting Bracket to the Box Hanger
.
5. Pass the long end clip through the large center hole to the underside of the mounting bracket clip
and then attach the bracket to the clip using the supplied screw (see
6. Hold the AP300 next to the mounting bracket to estimate the height of the T-bar box hanger to
provide enough clearance for the external antennas, which should be pointing down.
7. Adjust the height of the box hanger using the height adjusting screws (see
8. Clip the box hanger T-rail clips to the ceiling rails, making sure they are securely attached.
9. Connect a drop wire to a building structural element and through the hole provided in the bracket
mounting clip. The U.S. National Electrical Safety Code requires this additional support.
10. Connect the posts of the AP300 to the three keyholes of the mounting bracket and slide into the
keyhole, ensuring the locking detent is engaged. You will hear a click.
11. For each antenna, loosen the knurled ring at the base of the antenna (see
antenna down, then retighten the ring.
12. Connect one end of the PoE Ethernet cable to the Ethernet connector, shown in
13. Check that the AP300 is operating correctly before replacing the ceiling tile to the ceiling. Verify
correct operating using the LEDs, as shown in
Mount AP300 in a Hoffman Enclosure
To mount an AP300 in a Hoffman enclosure, follow these steps:
1. Place AP300 upside down on a soft flat surface.
2. Remove and discard the wall/ceiling mounting bracket (650-00064) if installed.
© 2008 Meru Networks, Inc.
Figure
Check AP300 LED
Activity.
Figure
11). One hole attaches
12).
Figure 12
for orientation).
Figure
10).
Figure
8), point the
Figure
11.
Installing the AP300
23

Advertisement

Table of Contents
loading

Table of Contents