Check Ap300 Led Activity; Figure 13 Ap300 Status Leds - Meru Networks AP320 Installation Manual

3. Remove and discard the four rubber feet.
4. If the unit has white antennas, remove them and attach the black antennas provided.
5. Position the Hoffman bracket (650-00128) onto the back of the AP300 with the four Hoffman
mounting screws facing downwards.
6. Using a Phillips screw driver, attach the bracket using the two supplied 6-32 3/16 SEMS screws (665-
00018).
7. Flip the assembly over and mount into the Hoffman enclosure, attach the Ethernet cable to the
AP300 rotating the assembly to allow ease of dressing the Ethernet cable within the enclosure.
8. Using a Phillips screw driver, tighten the four bracket screws to the enclosure.
9. Adjust the antennas as needed.

Check AP300 LED Activity

When the AP300 is first connects to the controller and any time the access point is rebooted, the AP
initializes with and then is programmed by the controller. When the AP is first powered up, all LEDs
are green. Thereafter, the Status LED color reflects the various operating states described in
After the AP300 is connected, check the status of the LEDs.
Figure 13: AP300 Status LEDs
The functions of the five LEDs are described below.
© 2008 Meru Networks, Inc.
S
R
L R
P
T
F
A F
W
A
2
N 1
R
T
Table 7.
Installing the AP300 24