Figure 29 Brackets Attached To A Pole - Meru Networks AP320 Installation Manual

Installing the Access Points
Note:
facing up.
Figure 29: Brackets Attached to a Pole
Attach the bridge
with bracket to
affixed plate on pole
3. Use the included nuts to tightly secure the wireless OAP180 to the bracket.
4. Connect the
Mounting OAP180 with the Wall-Mounting Bracket
Attach the bracket to a wall with the flat side flush against the wall. Follow these steps
to mount the unit to a wall using the wall-mounting bracket:
1. Position the bracket in the intended location and mark the position of the four
2. Drill holes in the wall that match the screws and wall plugs included in the bracket kit,
3. Use the included nuts to tightly secure the
4. Connect the two brackets as shown below.
50 Meru Access Point and Radio Switch Installation Guide
Always attach the bracket to a pole with the open end of the mounting grooves
bracket and the pole bracket.
OAP180
mounting screw holes.
and then secure the bracket to the wall.
to the bracket.
OAP180
© 2008 Meru Networks, Inc.