Figure 10 Mounting The Ap300 To A Suspended Ceiling Rail - Meru Networks AP320 Installation Manual

Figure 10: Mounting the AP300 to a Suspended Ceiling Rail
To mount an AP300 below a suspended ceiling:
1. Determine the location on the ceiling rail where the AP will be mounted and remove the ceiling
tiles.
2. Place each of the two caddy fasteners on the ceiling T-rail and twist to attach to the rail.
3. Adjust the distance between the caddy fasteners by using the mounting bracket holes as a guide.
4. Tighten the caddy fasteners in place using a standard screwdriver. Do not overtighten.
5. Place each spacer on the caddy fastener stud. The spacer legs should contact the ceiling T-rail.
6. Align the mounting bracket keyholes with the caddy fastener studs and slide the AP300 to the
narrow end of the hole.
7. Attach a keps nut to each caddy fastener stud and hand tighten. Do not overtighten.
8. Align the AP300 mounting posts over the circular portion of the keyhole mounts, push the AP in and
slide the AP down until it engages with the locking detents (see
in place.
9. For each antenna, loosen the knurled ring at the base of the antenna (see
antenna and then retighten the ring.
10. Connect one end of the PoE 100BaseT Ethernet cable to the 100/1000 Ethernet connector.
Caution!
mistakenly be plugged into the Console port.
© 2008 Meru Networks, Inc.
Be sure to connect the Ethernet cable to the Ethernet port; the cable can
Figure 10). You should hear it snap
Figure 8), orient the
Installing the AP300 21