Figure 18 Aligning The Ap200 With The Bracket - Meru Networks AP320 Installation Manual

Installing the Access Points
2. Drill holes at the locations you marked:
—
—
3. If you are using plastic anchors, install them in the holes.
4. Screw in the screws most of the way, so that the screw head is about 1/16 of an
5. Mount the bracket on the screws, placing the circular portion of the keyhole
6. Tighten the screws to secure the bracket.
7. Align the AP200 mounting posts over the circular portion of the keyhole mounts,
Mounting bracket attached to wall
Figure 18: Aligning the AP200 with the Bracket
34 Meru Access Point and Radio Switch Installation Guide
3/16-inch holes if you are using plastic anchors
1/8-inch holes if you are using only the screws
inch from the wall.
mounts over the screw heads and sliding the bracket down.
push the AP in and slide the AP down until it engages with the locking detents.
You should hear it snap in place.
© 2008 Meru Networks, Inc.