Where To Go From Here - Meru Networks AP320 Installation Manual

Where to Go From Here

Note:
Caution!
mistakenly be plugged into the Console port.
13. Check that the AP200 is operating correctly before replacing the ceiling tile to
Where to Go From Here
Now that the AP200 is installed, go to the Meru System Director Getting Started
Guide for instructions on initializing the controller and connecting the controller and
APs to the Ethernet switch to form the WLAN. Return to this chapter to check the
status of the LEDs once the WLAN is operational.
40 Meru Access Point and Radio Switch Installation Guide
For the AP201 and AP208 access points, a shielded Cat 5e (or greater)
Ethernet cable must be used in order to comply with international electro-
magnetic emissions limits.
If it is not practical to use shielded cables, contact Meru Support for a line
filter, available at no charge, that may also be used to ensure compliance.
Be sure to connect the Ethernet cable to the Ethernet port; the cable can
the ceiling. Verify correct operating using the LEDs, as shown in
Activity.
Checking LED
© 2008 Meru Networks, Inc.