Figure 15 Ap200 Antenna Connection - Meru Networks AP320 Installation Manual

Installing the Access Points
Horizontal Mounting
To horizontally mount an AP200:
1. Place the AP200 flat on the horizontal surface.
2. For each antenna, loosen the knurled ring at the base of the antenna (see
Antenna
Figure 15: AP200 Antenna Connection
3. Connect one end of the PoE 100BaseT Ethernet cable to the 100/1000 Ethernet
Note:
Caution!
mistakenly be plugged into the Console port (see
32 Meru Access Point and Radio Switch Installation Guide
Figure 15), point the antenna straight up, then retighten the ring.
Turn clockwise
to tighten
connector, shown in Figure
For the AP201 and AP208 access points, a shielded Cat 5e (or greater)
Ethernet cable must be used in order to comply with international electro-
magnetic emissions limits.
If it is not practical to use shielded cables, contact Meru Support for a line
filter, available at no charge, that may also be used to ensure compliance.
Be sure to connect the Ethernet cable to the Ethernet port; the cable can
16.
Figure 16).
© 2008 Meru Networks, Inc.