Where To Go From Here - Meru Networks AP320 Installation Manual

11. Connect the two Ethernet cables to the PoE device.
12. Apply power to the PoE component and network switch to power up the RS4000.
13. Test the reception for the antenna and then securely tighten the antenna.
14. Verify correct operating using the LEDs, as shown in "Checking LED Activity."
15. Close the lid to the Hoffman/NEMA enclosure.

Where to Go From Here

Now that the RS4000 is installed, go to the Meru System Director Getting Started
Guide for instructions on initializing the controller and connecting the controller and
RS4000 to the Ethernet switch to form the WLAN. Return to this chapter to check the
status of the LEDs once the WLAN is operational.
© 2008 Meru Networks, Inc.
Where to Go From Here
Installing the RS4000 91