Figure 20 Mounting The Ap200 To A Suspended Ceiling Rail - Meru Networks AP320 Installation Manual

Installing the Access Points
Mounting Below a Suspended Ceiling
The optional suspended ceiling mounting kit allows the AP200 mounting bracket to
attach to suspended ceiling T-rails (see
Note:
to attach the AP200 to the mounting bracket.
Figure 20: Mounting the AP200 to a Suspended Ceiling Rail
To mount an AP200 below a suspended ceiling:
1. Determine the location on the ceiling rail where the AP will be mounted and
2. Place each of the two caddy fasteners on the ceiling T-rail and twist to attach to
3. Adjust the distance between the caddy fasteners by using the mounting bracket
4. Tighten the caddy fasteners in place using a standard screwdriver. Do not
5. Place each spacer on the caddy fastener stud. The spacer legs should contact the
6. Align the mounting bracket keyholes with the caddy fastener studs and slide the
7. Attach a keps nut to each caddy fastener stud and hand tighten. Do not
36 Meru Access Point and Radio Switch Installation Guide
To comply with NEC code, attach a grounding wire to any of the screws used
Keps nuts with attached
locking washer
remove the ceiling tiles.
the rail.
holes as a guide.
overtighten.
ceiling
T-rail.
AP200 to the narrow end of the hole.
overtighten.
Figure 20).
Suspended ceiling T-rail
Caddy fastener(s)
Plastic spacer(s)
Mounting bracket
© 2008 Meru Networks, Inc.