Where To Go From Here - Meru Networks AP320 Installation Manual

8. Attach a keps nut to each caddy fastener stud and hand tighten. Do not
9. Align the AP150 with the bracket thumbscrews (see
10. For each antenna, loosen the knurled ring at the base of the antenna (see
11. Connect one end of the PoE 100BaseT Ethernet cable to the 100/1000 Ethernet

Where to Go From Here

Now that the AP150 is installed, go to the Meru System Director Getting Started
Guide for instructions on initializing the controller and connecting the controller and
APs to the Ethernet switch to form the WLAN. Return to this chapter to check the
status of the LEDs once the WLAN is operational.
© 2008 Meru Networks, Inc.
overtighten.
thumbscrews to attach the bracket.
Figure 33), point the antenna straight down, then retighten the ring.
connector, shown in (see Figure 34).
Where to Go From Here
Figure 36) and tighten the
Installing the AP150 69