Figure 49 Rs4000 With Antenna Attached - Meru Networks AP320 Installation Manual

Installing the RS4000
5. Pass the long end clip through the large center hole to the underside of the the
6. Hold the RS4000 next to the mounting bracket to estimate the height of the T-bar
7. Adjust the height of the box hanger using the height adjusting screws (see
8. Clip the box hanger T-rail clips to the ceiling rails, making sure they are securely
9. Connect a drop wire to a building structural element and through the hole
10. Align the RS4000 to the bracket and tighten the four knurled thumbscrews until
11. On the RS4000, attach the two antenna cables to the SMA antenna connectors
(Meru logo is upside down)
Figure 49: RS4000 with Antenna Attached
12. Attach at least one Ethernet cable to the Ethernet port labeled
13. Attach the antenna cables to the antenna, as described in "Placing and
14. Connect the Ethernet cables to the PoE device.
15. Apply power to the PoE component and network switch to power up the RS4000.
86 Meru Access Point and Radio Switch Installation Guide
mounting bracket clip and then attach the bracket to the clip using the supplied
screw (see Figure 48
box hanger to provide enough clearance between the RS4000 and the ceiling.
Figure 48).
attached.
provided in the bracket mounting clip. The U.S. National Electrical Safety Code
requires this additional support.
secure. If necessary, apply extra tightening with pliers.
labeled and
ANT1 ANT2
the cable ends clockwise until tight.
ANT1
optionally to on the top panel of the RS4000. If just ETH1 is connected, only
ETH2
two of the four radios will be active.
Positioning the Antenna." The antenna can also be mounted within the plenum
space if need be.
for orientation).
on the top panel of the RS4000 (see
ANT1
ANT2
K
Figure
ANT2
ETH1
ETH2
© 2008 Meru Networks, Inc.
43) by turning
and
ETH1