Where To Go From Here; Checking Led Activity; Ethernet Connector Leds; Figure 14 Rj-45 Leds - Meru Networks ap150 Installation Manual

Where to Go From Here

Now that the AP200 is installed, go to the Meru Wireless LAN Getting Started Guide for instructions
on initializing the controller and connecting the controller and APs to the Ethernet switch to form the
WLAN. Return to this section to check the status of the LEDs once the WLAN is operational.

Checking LED Activity

Access point status LEDs are provided on the Ethernet connector and on the face of the AP200.

Ethernet Connector LEDs

After the AP200 is connected, the LEDs near the RJ-45 connector should light, as shown in
Figure 14: RJ-45 LEDs
The green LED on the left blinks if any Ethernet activity is taking place. If there is no Ethernet activity,
the LED is off. The LED on the right is solid green if an Ethernet link is present. If no Ethernet link
is present or connectivity is lost, the LED is off.
Link present
Ethernet activity
Where to Go From Here
Figure
Installing the AP200
14.
19