Fcc Radiation Exposure Statement; Radio Frequency Interference Requirements - Meru Networks AP320 Installation Manual

Access point and radio switch
Table of Contents

Advertisement

Internal Use Only—Beta Draft
Use only with Listed I.T.E. equipment.
Notices
The unit is intended for installation in Environment A as defined in IEEE 802.3.af. All
interconnected equipment must be contained within the same building, including the
interconnected equipment's associated LAN connection.
Suitable for use in environmental air space in accordance with Section 300-22(c) of
the National Electrical Code, and Sections 2-128, 12-010(3) and 12-100 of the Cana-
dian Electrical Code, Part 1, C22.1.

FCC Radiation Exposure Statement

Caution!

Radio Frequency Interference Requirements

The Interference Statement applies to the following APs:
AP150
OAP180
AP201 Rev 2, AP208 Rev 2
AP300 series
RS4000
© 2008 Meru Networks, Inc.
The radiated output power of the Meru Networks devices is well below the
FCC radio frequency exposure limits. However, the Meru Access Points
should be used in such a manner that the potential for human contact dur-
ing normal operation is minimized. When installing and operating these
devices, keep a minimum distance of 20 cm (8 inches) between the anten-
nas and any persons/users in the vicinity.
FCC Part 15 Statement
This is to certify that the above models are shielded against the generation of
radio interference. Compliance is dependent upon the use of Cat 5e shielded
data cables or a Meru-supplied line filter. Contact Meru Support to obtain a line
filter, free of charge.
USA
Regulatory Information
117

Advertisement

Table of Contents
loading

Table of Contents