Figure 8 Rs4000 With Antenna Attached - Meru Networks AP150 Installation Manual

(Meru logo is upside down)
Figure 8: RS4000 with Antenna Attached
10. Attach at least one Ethernet cable to the Ethernet port labeled
11. Align the RS4000 to the bracket (against the wall) and tighten the four knurled
12. Attach the antenna cables to the antenna, as described in "Placing and
13. Connect the two Ethernet cables to the PoE device.
14. Apply power to the PoE component and network switch to power up the RS4000.
15. Verify correct operating using the LEDs, as shown in
© 2007 Meru Networks, Inc.
ANT1
optionally to on the top panel of the RS4000. If just ETH1 is connected, only
ETH2
two of the four radios will be active.
thumbscrews until secure. If necessary, apply extra tightening with pliers.
Positioning the Antenna."
ANT1 ANT2
ANT2
K
Installing the RS4000
ETH1
ETH2
and
ETH1
"Checking LED Activity."
Installing the RS4000 17