Figure 19 Sliding The Ap200 Into The Bracket - Meru Networks AP320 Installation Manual

Figure 19: Sliding the AP200 into the Bracket
8. For external antennas, loosen the knurled ring at the base of each antenna (see
9. Connect one end of the PoE 100BaseT Ethernet cable to the 100/1000 Ethernet
Note:
Caution!
mistakenly be plugged into the Console port.
© 2008 Meru Networks, Inc.
Figure 15), point the antenna straight up, then retighten the ring.
connector, shown in Figure
For the AP201 and AP208 access points, a shielded Cat 5e (or greater)
Ethernet cable must be used in order to comply with international electro-
magnetic emissions limits.
If it is not practical to use shielded cables, contact Meru Support for a line
filter, available at no charge, that may also be used to ensure compliance.
Be sure to connect the Ethernet cable to the Ethernet port; the cable can
Mounting bracket
16.
Installing the Access Points
Installing the AP200 35