Table of Contents
Advertisement
DGS-3130 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
Timeout
Click the Edit button to re-configure the specific entry.
Click the Apply button to accept the changes made.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
Static ARP
This window is used to display and configure the static ARP settings.
To view the following window, click L3 Features > ARP > Static ARP, as shown below:
The fields that can be configured are described below:
Parameter
IP Address
Hardware Address
Click the Apply button to accept the changes made.
Click the Edit button to re-configure the specific entry.
Click the Delete button to remove the specific entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
Proxy ARP
This window is used to display and configure the Proxy ARP settings. The Proxy ARP feature will allow the Switch to
reply to ARP requests destined for another device by faking its identity (IP and MAC Address) as the original ARP
responder. Therefore, the Switch can then route packets to the intended destination without configuring static routing
or a default gateway. The host, usually a Layer 3 Switch, will respond to packets destined for another device.
To view the following window, click L3 Features > ARP > Proxy ARP, as shown below:
Figure 6-2 ARP Aging Time Window
Description
After click the Edit button, enter the ARP aging timeout value here.
Figure 6-3 Static ARP Window
Description
Enter the IP address that will be associated with the MAC address here.
Enter the MAC address that will be associated with the IP address here.
184
Advertisement
Table of Contents
