DGS-3130 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
Unit
From Port - To Port
Notification
Subtype
Admin State
IP Subtype
Action
Address
Click the Apply button to accept the changes made.
NOTE: The IPv4 or IPv6 address entered here should be an existing LLDP management IP address.
LLDP Management Address List
This window is used to view the LLDP management address list.
To view the following window, click L2 Features > LLDP > LLDP Management Address List, as shown below:
Figure 5-745 LLDP Port Settings Window
Description
Select the Switch unit that will be used for this configuration here.
Select the appropriate port range used for the configuration here.
Select to enable or disable the notification feature here.
Select the subtype of LLDP TLV(s). Options to choose from are MAC Address,
and Local.
Select the local LLDP agent and allow it to send and receive LLDP frames on
the port. Options to choose from are TX, RX, TX and RX, and Disabled.
• TX - The local LLDP agent can only transmit LLDP frames.
• RX - The local LLDP agent can only receive LLDP frames.
• TX and RX - The local LLDP agent can both transmit and receive LLDP
frames.
• Disabled - The local LLDP agent can neither transmit nor receive LLDP
frames.
The default value is TX and RX.
Select the type of the IP address information to be sent. Options to choose from
are Default, IPv4 and IPv6.
Select the action that will be taken here. Options to choose from are Remove
and Add.
Enter the IP address that will be sent.
175